Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ plunger assembly instructions ”

RELATED FAQS

Resolution: Changing the plunger assembly on the AL-Series requires disassembling the chassis. Refer to Plunger Assembly Instructions for guidance.:

Does the Inpact EL94/95 have the same solenoid as the EL devices?

Resolution: As of 1/16/2013, the 113189-00 EL INPACT SOLENOID/PLUNGER ASSY is no longer available.:

How do you convert an AL44 to an AL40?

Resolution: To convert the AL44 to an AL40 you can replace the outside plunger unit in the chassis or order the AL40 chassis. Replacing the plunger unit is more difficult and time consuming and would not be r...:

Reinstalling an AD-993 Tailpiece Holder Assembly

Resolution: Below is the link to the document that shows how to install the AD993 tail piece assembly: Reinstalling an AD-993 Tailpiece Holder Assembly:

What would cause an EL device to pull and release?

Resolution: If your Von Duprin EL (solenoid) device pulls and releases quickly instead of holding the latch retracted, please check all of the items below.In most cases, one or more of these solutions will r...:

How do I prevent the ND85 button from rotating?

Resolution: In early 2013 the ND85 plunger assembly was improved to prevent accidental rotation of the inside button. The previous design could allow someone to unintentionally rotate the button and unknowing...:

What parts are modified when ordering an ND extended lock?

Resolution: Only the chassis components are modified for thicker door applications, the lever and spindle assemblies remain intact. The following parts may be modified depending on the function of the lock ...: