parts for nd locks interchangable cores

RELATED FAQS

Question
Answer
The ND-Series FSIC driver is part number N523-127.
The lever removal tool can be used to remove levers in both the ND and the L Series mortise locks.
On August 15, 2012 Schlage began shipping a new, more ergonomic, lever removal tool to coincide with Phase 1 of the ND-Series improvement project.  This tool can be used for Schlage ND-Series ...
Only the Schlage ND-Series can be prepped to accept non-Schlage cores. All designs are supplied with the appropriate tailpiece Non-Schlage cores are NOT included Lever designs available vary d...
The L9000 lock can be ordered for doors greater than 1 3/4" thick.  The allowable door thickness is dependent on the L lock function and how the lock is extended.  All locks for exte...
Only the chassis components are modified for thicker door applications, the lever and spindle assemblies remain intact.  The following parts may be modified depending on the function of the lock ...
Beginning March 14th, 2016, the electrified ND (ND12EL/EU; ND80EL/EU; ND96EL/EU) begin shipping with a new motor driven design which does not use an AC rectifier. (CAN NOT USE AC VOLTAGE WITH ...
As of February 2016, ND locks began shipping with a new latchbolt. The new latchbolt offers substantially improved performance in adverse door conditions (ex, with heavy door loading) andis more ro...
Prior to February 2016, using ND-Series locks on hollow metal doors required the use of latch spacers which prevent the latch from "fishtailing" (back end of latch moving from side to side). Latch ...
The default backset is 2 3/4" and the latch faceplate dimensions are 1 1/8" x 2 1/4". The latch supplied is the 13-047 deadlatch and 13-048 springlatch.