Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
Level five doors
”
RELATED FAQS
Question
Answer
How close can the top hinge be to the top of the door?
Resolution:
The minimum top and bottom butt hinge locations are as follows: To the hinge centerline: 4 1/2" and 5" hinges = 5 3/8" is the minimum location from top of door to centerline of the first hi...:
What is the standard screw size used on Steelcraft doors with 4 1/2" or 5" hinges?
Resolution:
Steelcraft follows the industry standards for hinge reinforcement and preparation for both door and frame. Unless otherwise specified all products prepared for butt hinges will have mounting holes ...:
Do Von Duprin Exit devices meet the 5 pound force requirement for opening an ADA handicapped door opening?
Resolution:
The 5 pound force requirement is in reference to the maximum force to swing the door, not the maximum force allowed to unlatch the exit device. Maximum allowed force to retract the Von D...:
Is the CS210 adjustable for either a 5 1/2" or 4" door prep?
Resolution:
The CS210 has a patented center-to-center adjustment that will switch from the standard 4" door prep to 5-1/2". Only these two dimensions are available.:
How do I use an AD-Series Relay Board (RLBD)?
Resolution:
This RLBD data sheet can also be found at Schlage/Technical Support. RLBD DataSheet :
Bullet Resistant Doors
Resolution:
At this time, Allegion does not supply products with bullet resistant ratings. Bullet resistant (BR) doors are designed to protect people and property from firearms’ bullets and shrapnel. ...:
What are door levels and models?
Resolution:
Levels and Models (covered in ANSI A250.8 (SDI 100) "Recommended Specifications for Standard Steel Doors and Frames") are SDI term aid in the selection and specification pr...:
How do I change signal levels on my PIM400 -TD2 outputs?
Resolution:
These SUS settings have no effect when the AD400 is linked to a PIM400-485; because the PIM400-485 reports the logic status with RSI-485 commands and not logic levels. The settings are gray...:
What's the maximum door width?
Resolution:
The maximum width door the Steelcraft can make is 4' 0":