Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
instruction manuel for falcon door closure
”
RELATED FAQS
Question
Answer
What template to use for the Falcon MA mortise lock?
Resolution:
The following templates are for the MA lock. Use the matrix in each template for the specific function. See here for Sectional trim . See here for Escutcheon trim. :
How do I remove an X lock from the door?
Resolution:
To disassemble an X lock, remove the inside knob and unscrew the inside collar and rose. The X lock spanner wrench (012172-000-30) can be used to depress the knob catch as well as tighten/loo...:
How do I cut a door to accept a Falcon W series lock?
Resolution:
For W lock levers, you can choose whether or not to install the mounting posts. This will also affect how the door is prepped so be sure to determine how you will install the locks befor...:
How does the MA531 operate?
Resolution:
MA531 (ANSI F20) Apartment Corridor Door Lock Latch bolt operated by knob/lever from either side, except when outside knob/lever is made inoperative by buttons in face. Dead bolt operated b...:
Explain the MA581 function
Resolution:
MA581 operation: Latchbolt operated by key from outside or by operating inside knob/lever. Outside knob/lever is always inoperative. Auxiliary latch deadlocks latchbolt when door is locked.:
Can a magnet, or sentronic device, be released and close the door from a button at a desk?
Resolution:
If a door is being held open by the LCN SEM 7800/1900 magnet or any ME/SE Series Sentronic LCN closer, you can remotely release that door to close by ordering the following parts and wiri...:
How do you adjust a door closer?
Resolution:
How to: What are the steps to adjust a door closer? Facts: All LCN and FALCON door closers will have 3 regulating valves and a spring adjustment. All cl...:
Can the Falcon 25-V be cut to fit on a 2' door?
Resolution:
The standard Falcon 25V vertical rod cannot be cut to fit on a 2 feet door opening. This device requires 2' 7 1/8" minimum door opening. Falcon offers a device that can be used on a 2 feet doo...: