Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
full size IC deadbolt
”
RELATED FAQS
Question
Answer
What is the part number for a control pin for a 23-030?
Resolution:
There are two parts that can be referred to as control pins for a 23-030 (FSIC core).C603-967 is the lower control pin that sits in the seventh hole of the FSIC plug. (part B in exploded view) ...:
What is the part number for T lock tailpiece used with a conventional cylinder?
Resolution:
Refer to Table 1 for a list of T lock tailpieces for conventional cylinders. Table 2 shows IC tailpieces. Table 1: T lock conventional tailpieces Table 2: T lock IC tailpieces:
Can the AL locks be ordered to accept Corbin Russwin core?
Resolution:
The AL lock can not be ordered to accept any competitor full size core. The ND lock should be used in these applications.:
Why can't I remove the control key from the core after the core is inserted into the lever?
Resolution:
The lever may be missing the slot feature for the core locking lug. Verify slot is in place.:
How to order a T series lock with a Corbin Russwin full size interchangeable prep.
Resolution:
Specify the J cylinder suffix followed by IC-CR6 or IC-CR7 (6 or 7 pin Corbin core) Example: T581J IC-CR6 This will accommodate an 8000 or 8000-7 Corbin Russwin Full Size core.:
I am unable to remove my key from a B600 B700 B800 deadbolt.
Resolution:
This is usually caused because the wrong tailpiece is being used on non-IC cylinders or the incorrect driver for IC options. Use the below descriptions to identify which they need.NON-IC: There are...:
Why is the plug pulling out of the FSIC 23-030 mortise housing?
Resolution:
ISSUE: After some use the plug will begin to project from the cylinder face and will ultimately pull completely out. ROOT CAUSE: In a dogged application the cam was rotated 180 degrees which ...: