Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ full glass door ept ”

RELATED FAQS

Resolution: Levels and Models (covered in ANSI A250.8 (SDI 100) "Recommended Specifications for Standard Steel Doors and Frames") are SDI term aid in the selection and specification pr...:

What is the maximum glass size available on the T-Series door?

Resolution: Glass lights are available in fire rated T-Series doors: Limited to one (1) light per door leaf with a maximum of 100 square inches of exposed glass. This applies to all hourly ratings a...:

What is the max rating available on an full glass (FG) door?

Resolution: A UL 20 minute fire rating is the maximum fire rating for a Full Glass (FG) door design. A14-Series door construction: Max fire rating is 20 minute. UL label only FG must use Over-Lapping Stee...:

What options are available on the CE-Series doors?

Resolution: CE Series door in a variety of embossed panel designs and gages. The CE series embossed panel doors also offer a wide range of specifiable options including sizes, and hardware prepar...:

What glass light kits are available in doors?

Resolution: Glass Light is a preparation in a door for view window, vision and/or glazing including glass stop and glazing bead and may also be refereed to as a lite.Doors are available with a wide v...:

What are the maximum door width and height sizes?

Resolution: Maximum nominal (overall) single door sizes are as follows:L-Series (Laminated Door)20 Gage = 3’ 0” wide X 8’ 0” high18 Gage = 4’ 0” wide X 10’ 0” high16 Gage = 4’ 0” wide X 10’ 0” high1...:

Why would a 4600 not open a full 90 degrees?

Resolution: A 4600 (4630/4640) not opening to a full 90 degrees could be caused by a couple things: The Opening Force could be set too low. Try increasing the opening force adjustment on the controller a 1/...:

Can Von Duprin GBK's be stacked up to clear a 9/16" glass bead on a fire door?

Resolution: You can only use one GBK Glass Bead Kit (1/4") per device on fire rated openings. Glass Bead Kit is for use on doors with raised glass beads.:

What is exposed glass size?

Resolution: When dealing with glass lights in doors, there are three (3) critical dimensions which must be coordinated: Exposed Glass Size (EGS) - the horizontal and/or vertical dimensional size of the vision...:

What is the part number for a L mortise lock spindle?

Resolution: The Schlage L-Series mortise lock spindle and spring part number can be found in the Table 1. Spindles and Springs Part Number Description L283-060 Spindle and spring, 1...:

Can a 3 hour A labeled Fire Door be prepped for multiple glass lights?

Resolution: A fire rated door for 3 hours can have one glass light maximum: 100 square inches and must have an approved glass (Firelite type) Max glass size cannot exceed 12" in width or 33" in height. Wi...:

How do you route the wires for an E996L trim through the exit device?

Resolution: The wires run through the device out to the EPT. See step 7 on page 5 of E996L instructions.:

What is the minimum dimension from the edge of the door to a glass light cutout?

Resolution: Minimum dimensions to cutouts for glass lights: Vertical edge of door to edge of cutout = 5 29/32" Top of door to top of cutout = 6" Bottom of door to bottom of cutout = 10" Reinforcing chann...:

Are window kits available for Steelcraft doors?

Resolution: Window kits are available for Steelcraft doors as either factory installed or prepared and installed by a distributor. Factory prepared light cutouts are supplied with Dezigner trim as ...:

Where is factory recommendation for location of an EPT?

Resolution: EPT installation guidelines are as follows: Recommended location is 6" below top hinge per template Steelcraft will locate the power transfer prep at the Von Duprin re...:

How is glass cutting size figured for standard or special glass light installed?

Resolution: The GCS (Glass Cutting Size) is determined by adding 1 1/4" to EGS (Exposed Glass Size) to both the height and width dimensions. Ex: EGS = 20" w. x 30" h. GCS = 21 1/4" wide x 31 1/4" high St...:

Are EPT preps available on the Paladin Series door?

Resolution: EPT power transfer preparations are available on the Paladin PW14-Series door and FP14-Series frame. Electrified hinges are available on the Paladin PW14-Series door&...:

What is DeZigner Trim?

Resolution: Basic glass trim details: :

Are multiple narrow lights available?

Resolution: Yes. Multiple glass lights are available on specific door series as a special option as noted below: L-Series and SL-Series: Core options - Standard honeycomb, polystyrene, polyurethane Lig...:

What is the maximum glass light size on a 90 min (1 1/2 hour) fire rated door?

Resolution: Standard listed wire glass: one (1) light with 100 in2 per door leaf max.Firelite or other appropriately listed glass:• FM maintains one (1) light with 100 in2 per door leaf max.• UL &...:

Does the wire size of an EPT affect the operation of an EL device?

Resolution: Since most wire transfer devices such as an EPT or electric hinges cannot provide large gauge wires, we take the small gauge wire into account when determining the overall wire size for the device....:

What is the maximum door size for UL fire rated doors?

Resolution: Maximum UL Fire Rated door sizes are as follows:A-Series:4' 0" X 8' 0" single door8' 0" X 8' 0” double door or pairsB-Series4' 0" X 10' 0" single door8' 0" X 10' 0” double door or pairsCE-Series:3'...:

Is replacement aluminum glass light trim available?

Resolution: Aluminum trim is not available. All of our current trim offerings are steel.:

Are Steelcraft doors and/or frames fire rated?

Resolution: Yes, Steelcraft doors and/or frames are available and can carry a UL, WH or FM label. The type of fire label (UL, WH or FM) is dictated by the specifications and local building code. Doors ...:

Are doors available for use with non Steelcraft window kits?

Resolution: Doors are available with cutouts only. This practice is used for field installation of aftermarket (non-Steelcraft) glass trim by either the distributor or end user. The following information must ...:

What cores are offered for insulated doors?

Resolution: Insulated Core Options: Steelcraft L-Series doors are available with the following 2 optional insulated cores: Polystyrene slab - this core is available in non fire rated and fire rated doors...:

What is the maximum glass light size on a 3 hour (180 minute) fire rated door?

Resolution: Maximum glass light sizes for 3 hour fire doors is as follows: Wire glass - not approved for use in 3 hour fire doors. Ceramic glass: UL & ITS/WH allow one (1) light with 100 square inc...:

What is the Multi Point LM9300 Series?

Resolution: MultiPoint locks are three-point locking systems that secure the door at three points – top, bottom, and traditional center latch location. Operating just like traditional locks, MultiPoint locks...:

What is the maximum door size for ITS/WHI fire rated doors?

Resolution: ITS/WHI is "Warnoch Hersey". ITS/WHI is the formal designation for Intertek Testing Services / Warnock Hersey. ITS/WHI is an independent agency with testing, listing, in-plant inspection, and label...:

What is a surface mounted door closer?

Resolution: Surface Mounted door closers are the most durable and common type of door closer. Mounted to the surface of the door or frame Can be configured (through installation or arm type) to meet a...:

What is the Falcon SZ-Series Door?

Resolution: Falcon SZ Series Door is the economy Steelcraft commercial grade door recommended light commercial applications when architectural specification are not needed. Options: The SZ-Series door is...:

Does Steelcraft have frame installation instructions?

Resolution: It is always recommended to point installers to the industry installation manuals which are very comprehensive and are ANSI documentsClick here to get the updated link to the Steelcraft Shop M...:

Are glass lights available in the H-Series door?

Resolution: Steelcraft offers all the standard lights as well as special size glass lights in the H-series door. Effective April 1, 2012, (Bulletin # B-100.12) the default for Dezigner Trim in H-Series D...:

Are stainless steel doors and frames available?

Resolution: Yes, stainless steel doors and frames are available. Door Construction: LS-Series: Visible edge seams Door construction similar to the ...:

Can a door have an InPact device and glass lights?

Resolution: Glass lights available: Standard Glass Lights - The N4, N5 & V lite can be used at standard locations with out any modification. Glass Light Options - Other glass lights are available but ...:

What are the minimum stile and rail dimensions for the L-Series door FG, FG2 & FG3?

Resolution: The minimum stile and rail dimensions are to exposed glass are: Stiles = 6 13/16" Top Rails = 6 3/4" Center Rails = 7 1/2" Bottom Rail = 10 3/4" For high traffic and high abuse locations th...: