field wiring cable for cx part number

RELATED FAQS

Question
Answer
The part number for "CX Wiring Assembly" also called "Ten Wire Connector" is 112018-00.
The Trim/Device Cable part number is 040193.  If a Chexit device is ordered with an E996/RX996/E7500 from the factory, the trim/device cable is automatically furnished at no additional ch...
You must replace the entire RX switch assembly for Chexit devices shipped after 8-24-2015 with motor driven.
The part number for the RX switch pig tail (black plug) with two orange wires only for Chexit devices shipped prior to 8-24-2015 with solenoid driven is 991338-00. 
Chexit devices shipped after 8-24-2015 with motor driven:Attached is the installation instructions of the the Von Duprin Chexit devices that includes the wiring diagrams.Installation Instructions&n...
Chexit devices shipped before 8-24-2015 with solenoid driven:Attached are the single and double door wiring , cable voltage reading documents for trouble shooting, and the installation in...
The circuit board is sometimes referred to as a "module" in the field.
If the horn fail to operate in the CX device you need to replace the Chexit module. 040086 is the part number for devices shipped after 8-24-2015 with motor driven.050228 is the...
113781 is the part number for Von Duprin 15 second CX sign.
For motor driven Chexit devices shipped from the factory after 8-24-2015, the RX switch is standard, part number 116717-00.    
For solenoid driven Chexit devices shipped from the factory prior to 8-24-2015, the RX switch is ordered as a "Special CX-RX switch" by SSC or distributors.  The switch may only be installed o...
A replacement BNC cable has been found through the manufacturer, E-Z Hook.  This company makes electronic testing equipment, and this cable is believed to be a good working replacement fo...
This product is obsolete and is no longer available from Schlage Electronics.