Falcon emergency tool

RELATED FAQS

Question
Answer
The emergency keys are shipped with each lock.  The part numbers are; 61-509 standard and 61-510 large bow size.
AL-Series and discontinued D Lever-Series locks use castle nuts to hold the chassis to the spring cages and to keep the chassis positioned in the door. This causes confusion at times when the lock ...
L9040 locks WITHOUT indicator uses an emergency tool available in the price book, L583-233.L9040 locks WITH an indicator requires a small flat blade screwdriver.
The L583-233 emergency key spindle length is 1.575"The L583-233 emergency key will operate on a door thickness up to 3" extended equally. 
Within CDT (Configuration and Demonstration Tool), the usable COM port range is 1 - 6.
The software will not allow higher COM ports to be used.
If your computer has set the COM port for the serial connection to higher than 6, the setting must be adjusted in device manager to a lower port to enable CDT to communicate with the PIM.
Part numbers listed below:
The blue lever tool remover, 24002693, is not shipped in every box. The existing wire spring lever removal tool will be included in every box.  
A flat head screwdriver can be used or the 35-250 emergency key.
Used for installing interchangeable core housings.
See attachment that describes this tool.
The ND40 outside emergency button and the ND44 outside emergency turn button can disengage from the lever and fall out when they are not assembled properly.Click here for emergency button...
 If the button and plunger or emergency cylinder are damaged they can be ordered separately.  Part numbers are below.  Emergency Button and Plunger (ND40) - N123-034Em...
 See the attached Technical Note for instructions on saving a "Device Template" FROM a device or loading TO a device, Device Template Tech NoteOn the SUS/HHD go to the LOCK Properties tab, and sele...
The part number is 48-102 C, you will need to specify the cuts.
The lever removal tool can be used to remove levers in both the ND and the L Series mortise locks.
On August 15, 2012 Schlage began shipping a new, more ergonomic, lever removal tool to coincide with Phase 1 of the ND-Series improvement project.  This tool can be used for Schlage ND-Series ...
M504-271 is the emergency key used to open a locked S40.
The current tools, pinning kits and key originating machines for all Schlage Everest full size cylinders and small format cores are the same used on Everest 29.
Pricing information is not a part of the Knowledge Center data. For all hollow metal price comparisons please e-mail the Steelcraft Estimating Team. For your reference, the e-mail address...
Only the lever return spring is available.
Related solution: What is the part number for the lever return spring for the old M series mortise lock?
Order the M204-198 thru-bolt jig, see Figure 1. Figure 1: M204-198 thru bolt jig The 40-080 was the old Schlage jig. The 030736-000-70 was the old Falcon jig.  When the jig changed to...