Falcon EL wiring

RELATED FAQS

Question
Answer
EL wiring harness is no longer needed with new EL potted modules.
The EL wiring adapter is not needed for QEL devices.
Reference The 914 Installation instructions.
Yes, the QEL device includes a cable assembly part number 110388-00.Since 12/2014, that cable comes in a package (part 116549) with the long cable mentioned above and the small cable that plug...
Products shipped on or after August 8, 2012 no longer require the EL wiring adaptor.
  The part number for EL wiring adaptor is 44486876-00.  The part number contains two adaptors.
The EL Wiring Adapter is not needed for a CX device.
Products shipped on or after August 8, 2012 no longer require the EL wiring adaptor. The ELK Wiring Adaptor (900ELK) was used only when using the PS914 power supply with either the 900-2RS or 900-...
 EL devices are wired to the Senior Swing, using the P10 (761465) cable.  Connect the "GRAY" wire to the SC terminal on the 900-2RS card in the Von Duprin Power Supply and the "VIOLET" wire to the ...
The 4600 Series operator has both a 12VDC and 24VDC output rated at 1A (combined load) to power strikes, maglocks, and other devices, but an EL device "always" has to have a separate PS914-2RS Seri...
Use a normally closed fire alarm as the input to the power supply option board (PS873-2 or PS914-2RS), this will hold the latch retracted.  During a fire alarm, the contact will open, dropping...