Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
everest ic rim cylinder tailpiece
”
RELATED FAQS
Question
Answer
What is the part number for the Schlage small format rim cylinder tailpiece?
Resolution:
B502-899 is the tailpiece for both the SFIC and standard rim cylinders.:
What is the tailpiece and driver part number for the 20-057?
Resolution:
The B220-001 is an FSIC rim tailpiece and driver.:
What is the maximum door thickness a Rim cylinder can fit on?
Resolution:
For total thickness measurements larger than 3 inches see the special cylinder offerings in the Schlage Pricebook. Specify the part number and include the total thickness. We do no...:
Will Falcon B locks prepped for BD accept a 6 or 7 pin core?
Resolution:
The B series accepts 6 or 7 pin small format cores when specifying with the "BD" cylinder suffix (less small format interchangeable core). The tailpiece shown below is used for bo...:
When ordering the ND lock less cylinder will it come with a tailpiece?
Resolution:
The Schlage ND is shipped with a driver/tailpiece when ordered with a LD, BD, or JD suffix.:
Does the Schlage SFIC rim housings accept both 6 and 7 pin IC cores?
Resolution:
The Schlage small format interchangeable core rim cylinders 80-329, 80-159, 80-116, and 08-129 can accept 6 pin and 7 pin small format cores.:
Which way is the tail piece of the rim cylinder is inserting into the Von Duprin 98/99 rim device from 996L trim?
Resolution:
The tailpiece of the rim cylinder can be inserted into the Von Duprin 98/99 rim device either vertical or horizontal.:
Can I get the T series with a Schlage Full Size Interchangeable core?
Resolution:
The T lock can accept a Schlage Full Size core, but the cylinder suffix must be specified as "J IC-SC" so the correct parts are supplied (including the tailpiece) Example: T581J IC-SC:
What is the length of a Schlage rim cylinder?
Resolution:
The Schlage rim cylinder lengths are given below and were measured from the face of the cylinder to the back of the tailpiece. Because of allowable tolerances for each part the average length is l...: