Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ EL RX METAL DOOR PREP ”

Resolution: The hole should be drilled in the field once the end cap is located on the door. It is a 5/8" hole, that is located 5/16" from the end of the mechanism case. See installation instruction of t...:

Does Ives offer a continuous hinge or pivot for lead lined doors?

Resolution: Ives does not offer a continuous hinge designed specifically for lead lined doors. Standard hinges may work if the hinge and mounting hardware do not penetrate the lead lining in the door.&nb...:

Does the door prep need to be altered when ordering the L9000 locks lead lined?

Resolution: The door template L1 states: "Lead Lining: When L9000-Series or L400-Series locks are ordered with lead lining, add 1/8" to the width of the mortise cut-out on the lock case cover side of installa...:

Can doors be prepared for raceways in the factory?

Resolution: Raceway availability: Optional factory installed raceways are available in doors but are not available in frames. Preparation Info: Steelcraft installs a flexible 3/4" ID steel...:

Can you use a Von Duprin 94/95 Inpact device on a wood door?

Resolution: The Von Duprin 94/95 series Inpact devices can only be installed on metal doors as there would not be enough material left in the wood door after cutting out the 94/95 device prep to maintain door ...:

What is (SD) Special Dogging?

Resolution: SD is Special cylinder dogging in the center case of 98/99 rim and vertical rod non fire rated devices and is available with standard, EL, QEL, CX and ALK.:

What are the Von Duprin part numbers for RX, LX and RX,LX-LC switch kits for field installation?

Resolution: The attached table shows the part numbers for LX-RX and LX-RX-LC switches field installed.:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ EL RX METAL DOOR PREP ”

RELATED FAQS