deviated finishes for button push

RELATED FAQS

Question
Answer
Swapping out the following parts of an ND50 will convert it to an ND53: Swap N123-028 Push button plunger for  N123-017, Push and Turn button plunger Swap N523-000, Push button for N523-001 Pus...
Locknetics company supplied electro-magnetic locking devices, electronic smart locks, and electronic security components to access control dealers and lock smiths.  Ingersoll-Rand acquired ...
The 4630/4640 operator can accept any ( normally open / dry contact) actuator - hardwired or wireless.  LCN Wireless actuators require the use of the 8310-865 RF receiver.The 8310-856 RF ...
The 8200 console has both maintained(8200AS) and momentary (8200MS).
To replace the pushbuttons, remove the switch connector from the console main board Then press the pushbutton from the inside of the panel face out through the hole. There will be some resist...
The 25-R or 25-V device does meet the trim input requirements set by KABA for their trim so the two should be compatible.  However, the KABA trim has never been tested in house for the Fa...
Changing the plunger assembly on the AL-Series requires disassembling the chassis.  Refer to Plunger Assembly Instructions for guidance.
A design change occurred in 2001 to address a locking/unlocking issue with the discontinued D73 lever locks.  This included modifying the cam and plug, spindle and using a different plung...