Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
Designer trim installation
”
RELATED FAQS
Question
Answer
What different A-Series knob designs are available?
Resolution:
Discontinued: Bell, Claremont, Crown, Hanover, Lotus, Luna, Magnolia, Meteor, Novo, Saturn, Water Lily, Woodside.:
Can danmark lever designs be used on Von Duprin Exit Device trims?
Resolution:
Von Duprin does not offer any of the danmark lever designs by Schlage.:
What is DeZigner Trim?
Resolution:
Basic glass trim details: :
How to install an L9000 mortise lock less outside rose trim?
Resolution:
The L283-150 is a modified mounting plate to allow a user to only install trim on the inside of the L9000. For installation and door prep requirements, see the install sheet. Add...:
Are doors available for use with non Steelcraft window kits?
Resolution:
Doors are available with cutouts only. This practice is used for field installation of aftermarket (non-Steelcraft) glass trim by either the distributor or end user. The following information must ...:
Does Steelcraft have frame installation instructions?
Resolution:
It is always recommended to point installers to the industry installation manuals which are very comprehensive and are ANSI documentsClick here to get the updated link to the Steelcraft Shop M...:
Where is the template for the 718 trims made after 2/28/2011 for Falcon/Monarch concealed vertical rod devices?
Resolution:
Templates for current 718 series trim can also be found on Falcon website:
Why would the 996L trim not lock or unlock when installed with 98 or 99EO?
Resolution:
The 98/99 rim and vertical rod exit devices are shipped with NL drive screw to function as a Night Latch. To convert the device to Class Room, remove the NL Drive Screw on 98/99 center case ass...:
Does the Von Duprin E996L trim require the NL drive screw be installed into the device to function properly?
Resolution:
Von Duprin 98/99 NL drive screw is located in back of the 98/99 center case assembly. NL drive screw should be left in with trim lock slide plate in up position in the 98/99 exit device with E99...: