deadbolt tailpiece for full size IC

RELATED FAQS

Question
Answer
Refer to Table 1 for a list of T lock tailpieces for conventional cylinders.  Table 2 shows IC tailpieces. Table 1: T lock conventional tailpieces Table 2: T lock IC tailpieces
ISSUE: After some use the plug will begin to project from the cylinder face and will ultimately pull completely out. ROOT CAUSE: In a dogged application the cam was rotated 180 degrees which ...
Image-1 below shows an exploded view of a Full Size IC core with the bottom pin circled in red.  This pin controls the lug that locks the core into place when inserted into a lever or hou...
The T lock can accept a Schlage Full Size core, but the cylinder suffix must be specified as "J IC-SC" so the correct parts are supplied (including the tailpiece) Example: T581J IC-SC
The B series accepts 6 or 7 pin small format cores when specifying with the "BD" cylinder suffix (less small format interchangeable core).  The tailpiece shown below is used for both...
The Schlage ND is shipped with a driver/tailpiece when ordered with a LD, BD, or JD suffix.
The AL lock can not be ordered to accept any competitor full size core.  The ND lock should be used in these applications.
Only the Schlage ND-Series can be prepped to accept non-Schlage cores. All designs are supplied with the appropriate tailpiece Non-Schlage cores are NOT included Lever designs available vary d...
Specify the J cylinder suffix followed by IC-CR6 or IC-CR7 (6 or 7 pin Corbin core) Example: T581J IC-CR6  This will accommodate an 8000 or 8000-7 Corbin Russwin Full Size core.