Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
al series cutsheet
”
RELATED FAQS
Question
Answer
AL-Series Plunger Assembly Instructions
Resolution:
Changing the plunger assembly on the AL-Series requires disassembling the chassis. Refer to Plunger Assembly Instructions for guidance.:
Schlage AL small format spacer installation requirements.
Resolution:
The Schlage AL-Series SFIC locks require one (1) small format spacer (D500-000) for 7-pin cores and two (2) small format spacers for 6-pin cores. When these spacers are not ins...:
How do you convert an AL44 to an AL40?
Resolution:
To convert the AL44 to an AL40 you can replace the outside plunger unit in the chassis or order the AL40 chassis. Replacing the plunger unit is more difficult and time consuming and would not be r...:
What is GrainTech?
Resolution:
GrainTech® is a Steelcraft door option which provides a wood grained pattern which is embossed into both face sheets of the door. GrainTech doors are factory stained and top coated with a cle...:
Is there a tool to drill the thru bolt holes on cylindrical locks?
Resolution:
Order the M204-198 thru-bolt jig, see Figure 1. Figure 1: M204-198 thru bolt jig The 40-080 was the old Schlage jig. The 030736-000-70 was the old Falcon jig. When the jig changed to...:
What backsets are available on Schlage and Falcon locks?
Resolution:
SCHLAGE locks are available with the following backsets: Lock Series Lock Type  ...:
What is the new option for the old 873-AC board?
Resolution:
When the new PS900 series power supplies were created we did not pursue a version of these option boards. Need to discuss the specific hardware they are using and requirements to determine the app...:
How do you remove an AL series lever?
Resolution:
See instructions below. :