AL lock with sargeant

RELATED FAQS

Question
Answer
Only the Schlage ND-Series can be prepped to accept non-Schlage cores. All designs are supplied with the appropriate tailpiece Non-Schlage cores are NOT included Lever designs available vary d...
The AL lock can not be ordered to accept any competitor full size core.  The ND lock should be used in these applications.
The AL lock will be shipped with two spacers.  Use two spacers for 6-pin cores and use one spacer for 7-pin cores.
The part number for one spacer is D500-000.
The new AL FSIC driver part number is A700-052.  This driver snaps onto the back of the core similar to the ND, as opposed to it being assembled into the lock chassis with a retaining ring.  Th...
This is available, specify 41-005 for an extension link that is used with a 2 3/8" latch to effectively make a 5" backset.
Warranty Statement3 Year Limited Mechanical Warranty and 1-Year Limited Electromechanical Warranty - Additional warranties listed below The provisions of these limited warranties do not apply to P...
Schlage offers the AL170 single dummy trim, but for applications where a double dummy is needed you can install two AL170 dummy trims back-to-back.  Each AL170 is shipped with a threaded rod (part ...
Order the M204-198 thru-bolt jig, see Figure 1. Figure 1: M204-198 thru bolt jig The 40-080 was the old Schlage jig. The 030736-000-70 was the old Falcon jig.  When the jig changed to...
In 2002 the Schlage AL-Series underwent a design change that affected the spring cage, driver, and plastic insert.  Spring cage and driver replacements for AL locks manufactured before this design ...
AL-Series and discontinued D Lever-Series locks use castle nuts to hold the chassis to the spring cages and to keep the chassis positioned in the door. This causes confusion at times when the lock ...