Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ ad series installation template ”

RELATED FAQS

Question
Answer
What is the SUS feature "Device Template"
 See the attached Technical Note for instructions on saving a "Device Template" FROM a device or loading TO a device, Device Template Tech NoteOn the SUS/HHD go to the LOCK Properties tab, and sele...
Stile Size
The minimum recommended Stile measurement is 5” to allow proper mounting of the AD and CO series locks.
Why do AD Series offline locks still give a Low Coin Cell indication after I install a new coin cell?
Coin cell replacement is not immediately registered by the AD200/250 firmware.
Performing a processor reset (pressing and releasing S1 on the Main PCB Assembly) will register the new coin cell.
Cycling lock power (i.e., disconnecting and reconnecting the "AA" battery pack) will register the new coin cell.
The coin cell part number is CR2025 - 3 volt lithium - available at most battery or electronics stores.
Why can't I get my JD YA6 cylinder to install into an AD-Series lock?
The JD YA6 tailpiece is intentionally designed such that the tailpiece cannot be installed at the same time as the cylinder.  Interchangeable cylinders assume that the lever and taipiece is in...
See the JD Yale Lever installation instruction HERE