Schlage Electronics

Question
Answer
For RS-422 wiring: DC-104 HK-2 set dipswitch to: wire to: pin: RS-422 ...
Here are the steps needed to create their custom Mifare configuration using DX2400 Xceed cards and the HandNet Lite software. Handnet Lite version 2.3.1.9 which is available on our FTP site, is req...
Make sure you're logged into Handnet Lite Click on the 'Status' tab - locate the reader you will be using to enroll the new user - make sure that the circle / dot to the left of the network nam...
How to upgrade the memory on a FingerKey ReaderIn order to upgrade the memory of a FingerKey Reader a code must be obtained through the Ingersoll Rand Schlage Biometrics’ Order Management Group. If...
Log in is "1234" and the password is "new".
Log in is "1234" and the password is "new".
For wiring information on the DC-104 data converter for Biometric FingerKey products refer to  DC-104 technical note
Fingerkey memory upgrade
Fingerkey Ethernet upgrade
Bright blue can be configured to work with a biometric HandKey.  See the technical note below for set-up requirements.  The technical note also includes detailed instructio...
bright blue and Biometrics setup
The Fingerkey has card reader emulation mode of Weigand and Mag Stripe.
The Fingerkey DX2000 has inputs for 26 bit, 9 bit ID weigand. Also an optional Mage stripe, Bar code, and smart card.
The ID length for any Fingerkey is 1-15 digits.
The user memory on the DX2000 Fingerkey is 250 users and is expandable to 2,000 users.Standard Memory = 250 usersFPM-500 = Memory Expansion from 250 to 500 usersFPM-2000 = Memory Expansion from 250...
The FingerKey product line was officially discontinued as of February 2011.  The process began in September 2010 however, as of February 2, 2011, no new orders were accepted and any parts left...
To contact technical product support for Schlage Biometric Solutions products:Telephone:  877-671-7011, Option 2 (Product Support), Option 8 (Readers, Credentials, Biometrics)Email:  read...
If you know the IP address of the device (such as an ethernet card), you can find the MAC address by logging onto a PC that is plugged in on the same network as the device (said ethernet card);&nbs...
If you can ping the IP address of your handreader (assuming there is no other device with the same IP address on your network), the physical connection is established. Let's test the next level of ...
If you used the default installation, you can find the SchlageCommDaigs icon at: Start -> All Programs -> Recognition Systems -> RSI .NET 2.0 DLL -> SchlageCommDiags.exeIf no modems are...
check to see if the user access profiles are set to 'Never'; if they are, change them to 'always' and download users again.Here's how: - in Handnet Lite, go to the 'Users' tab and look at the ...
For the E-series and F-series handreaders and the (obsolete) Fingerkey readers, we currently offer only the .NET SDK for Windows. If the customer is interested in developing software applications f...
The HK-2 or FingerKey will lose its enrolled readers under the following conditions:   - if you ‘cold boot’ or reset the reader to factory defaults   - if you connect to Handn...
Delete users under password 4.
Yes, the F-series SDK includes commands that will work with the E-series, but not all SDK commands are compatible with the E-series. The Programming Guide (which is included with the SDK) lists wha...