Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

How can an old 4610 be wired up sequentially to a new 4630?

Resolution:

You can accomplish this by:

using a LCN 8310-865 receiver on each unit and going to wireless actuators.
using a Sequential relay/module.

Unfortunately an old 4610 or 4620 unit cannot be hardwired to a 4630 or 4640 unit to get a sequential operation. This is because with the component upgrades to the 4630 (40) units the internal board logic is not the same as the old 4610 (20) units. You can only hard wire them together to open simultaneously.

DISCLAIMER:

INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.

YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.