Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

HandKey F-Series Ethernet EN-100 or EN-200 Network Requirements

HandKey F-Series Ethernet EN-100 or EN-200 Network Requirements

Ethernet Minimum Requirements
- A TCP/IP network
- CAT 5 cable or better
- 10baseT
- Static IP address, gateway and subnet addresses (if needed)
- TCP Port 3001 must be opened

Have the system administrator set Port 3001 to allow access on all switches and routers between the EN-100/200 and host program.

The EN-100/200 does not support DHCP; therefore a static IP address is required and must be programmed into the reader before the adapter will communicate with the network.


Full EN-100/200 Field Installable Ethernet Instructions found at:

http://us.allegion.com/IRSTDocuments1/70200-0014_J_Ethernet%20Upgrade.pdf


DISCLAIMER:

INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.

YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.